Gage Making And Lapping
Gage Making And Lapping
The book Gage Making And Lapping was written by author Here you can read free online of Gage Making And Lapping book, rate and share your impressions in comments. If you don't know what to write, just answer the question: Why is Gage Making And Lapping a good or bad book?
Where can I read Gage Making And Lapping for free?
In our eReader you can find the full English version of the book. Read Gage Making And Lapping Online - link to read the book on full screen. Our eReader also allows you to upload and read Pdf, Txt, ePub and fb2 books. In the Mini eReder on the page below you can quickly view all pages of the book - Read Book Gage Making And Lapping
In our eReader you can find the full English version of the book. Read Gage Making And Lapping Online - link to read the book on full screen. Our eReader also allows you to upload and read Pdf, Txt, ePub and fb2 books. In the Mini eReder on the page below you can quickly view all pages of the book - Read Book Gage Making And Lapping
What reading level is Gage Making And Lapping book?
To quickly assess the difficulty of the text, read a short excerpt:
A coating of lead is cast over the surface of the lap, and then hammered to make it compact. A galvanized iron pan B is provided, the edges of which project above the surface of the lap to prevent the liquid, or whatever is used, from flying off, and onto everything around. Another handy device on this lap is a bar which is provided with ways and a sliding head C which can be pushed from the outer edge to the center of the lap. The bar is fastened to lugs which project on opposite sides of the ...frame, and can readily be removed when not in use. The bar is also provided with adjusting screws to set it parallel with the surface of the lap or to set the sliding head square with the surface. The sliding head has a square corner and an angle * MACHINERY, August, 1908 THE ROTARY LAP groove which can be used for lapping the ends of round or square pieces.
The engraving Fig. 30 shows a good way of making a lap for cylin- drical work in the lathe. A piece of wrought iron pipe about 2 inches long, with a number of 5/16-inch holes drilled through will answer the purpose.
What to read after Gage Making And Lapping?
You can find similar books in the "Read Also" column, or choose other free books by Frank E Shailor to read onlineMoreLess
To quickly assess the difficulty of the text, read a short excerpt:
A coating of lead is cast over the surface of the lap, and then hammered to make it compact. A galvanized iron pan B is provided, the edges of which project above the surface of the lap to prevent the liquid, or whatever is used, from flying off, and onto everything around. Another handy device on this lap is a bar which is provided with ways and a sliding head C which can be pushed from the outer edge to the center of the lap. The bar is fastened to lugs which project on opposite sides of the ...frame, and can readily be removed when not in use. The bar is also provided with adjusting screws to set it parallel with the surface of the lap or to set the sliding head square with the surface. The sliding head has a square corner and an angle * MACHINERY, August, 1908 THE ROTARY LAP groove which can be used for lapping the ends of round or square pieces.
The engraving Fig. 30 shows a good way of making a lap for cylin- drical work in the lathe. A piece of wrought iron pipe about 2 inches long, with a number of 5/16-inch holes drilled through will answer the purpose.
What to read after Gage Making And Lapping?
You can find similar books in the "Read Also" column, or choose other free books by Frank E Shailor to read onlineMoreLess
Read book Gage Making And Lapping for free
Write Review:
User Reviews: