The Management of Steel
The book The Management of Steel was written by author Here you can read free online of The Management of Steel book, rate and share your impressions in comments. If you don't know what to write, just answer the question: Why is The Management of Steel a good or bad book?
Where can I read The Management of Steel for free?
In our eReader you can find the full English version of the book. Read The Management of Steel Online - link to read the book on full screen. Our eReader also allows you to upload and read Pdf, Txt, ePub and fb2 books. In the Mini eReder on the page below you can quickly view all pages of the book - Read Book The Management of Steel
In our eReader you can find the full English version of the book. Read The Management of Steel Online - link to read the book on full screen. Our eReader also allows you to upload and read Pdf, Txt, ePub and fb2 books. In the Mini eReder on the page below you can quickly view all pages of the book - Read Book The Management of Steel
What reading level is The Management of Steel book?
To quickly assess the difficulty of the text, read a short excerpt:
If for a long screw-tap or rimer, three-quarters of an inch in diameter, seven- eighths round-bar steel swaged down at a cherry-red heat to three-quarters and a sixteenth will suffice (the one-sixteenth is allowed for turning) ; but if the edges of seven-eighths square steel be hammered down so as to form eighth squares and then swaged EXPANSION AND CONTRACTION OF STEEL. 195 down to three-quarters and a sixteenth, it will prove even better for the purpose than the seven- eighths round-bar steel... ; it must be obvious that if similar methods be adopted with larger articles, they will be less liable to break in hardening.
To make mistakes at times is the common expe- rience of all. It may therefore not be out of place to say a few words upon such pieces of iron-work as the mechanic may have the misfortune, through some oversight or other, to bore too large, and which would in some instances cause the work to be useless for the purpose for which it was intended were it not possible to contract the hole.
What to read after The Management of Steel?
You can find similar books in the "Read Also" column, or choose other free books by George Ede to read onlineMoreLess
To quickly assess the difficulty of the text, read a short excerpt:
If for a long screw-tap or rimer, three-quarters of an inch in diameter, seven- eighths round-bar steel swaged down at a cherry-red heat to three-quarters and a sixteenth will suffice (the one-sixteenth is allowed for turning) ; but if the edges of seven-eighths square steel be hammered down so as to form eighth squares and then swaged EXPANSION AND CONTRACTION OF STEEL. 195 down to three-quarters and a sixteenth, it will prove even better for the purpose than the seven- eighths round-bar steel... ; it must be obvious that if similar methods be adopted with larger articles, they will be less liable to break in hardening.
To make mistakes at times is the common expe- rience of all. It may therefore not be out of place to say a few words upon such pieces of iron-work as the mechanic may have the misfortune, through some oversight or other, to bore too large, and which would in some instances cause the work to be useless for the purpose for which it was intended were it not possible to contract the hole.
What to read after The Management of Steel?
You can find similar books in the "Read Also" column, or choose other free books by George Ede to read onlineMoreLess
Read book The Management of Steel for free
You can download books for free in various formats, such as epub, pdf, azw, mobi, txt and others on book networks site. Additionally, the entire text is available for online reading through our e-reader. Our site is not responsible for the performance of third-party products (sites).
Write Review:
Guest
Read Also
7 / 10
8 / 10
User Reviews: